Not sure what I have here

Vic103 · 08-17-2012, 08:22 PM

Thank you for the infro Norme. I have the 5.0mm one.

I got the barrel clocked and sight leveled, Woot Woot!!

I figured I would have to take .006 thousands off the barrel sholder to give me 1/8th away for torqueing purposes. I took off about .004 and said I better check it (can always take more, but when it's gone it's gone). Good thing, it was 1/8th turn away ...whew. Torqueed up nice.

I loaded a snap cap and it feeds and ejects great. All I got to do now is check the headspace. This won't be for a while though. The go nogo gages are like 62.00 USD at Brownells. I just can't afford this right now and if I need a reamer, oh boy another 70 bucks. I been spending a lot lately on gun stuff and the wife is starting to get a little upset........hehe. Oh well I'll just have to look at it, take the clip in and out, in and out, load and eject the snap caps. Man......I want to shoot it!!!

Here are more pics:

wdavid431 · 08-18-2012, 08:33 AM

Your pistol is looking very good. I think you are doing a great job on it. By the way what is the suffix on the Arty barrel? I have one with the same suffix looking mark but am unable to decide exactly what letter it is. And I hope you will be keeping the Arty barrel.

08-18-2012, 08:33 AM	#2
wdavid431 User Join Date: Jan 2006 Location: Arkansas Posts: 135 Thanks: 0 Thanked 4 Times in 4 Posts	Your pistol is looking very good. I think you are doing a great job on it. By the way what is the suffix on the Arty barrel? I have one with the same suffix looking mark but am unable to decide exactly what letter it is. And I hope you will be keeping the Arty barrel. __________________ W David

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

08-17-2012, 08:22 PM	#1
Vic103 User Join Date: Aug 2012 Posts: 28 Thanks: 0 Thanked 7 Times in 5 Posts	Thank you for the infro Norme. I have the 5.0mm one. I got the barrel clocked and sight leveled, Woot Woot!! I figured I would have to take .006 thousands off the barrel sholder to give me 1/8th away for torqueing purposes. I took off about .004 and said I better check it (can always take more, but when it's gone it's gone). Good thing, it was 1/8th turn away ...whew. Torqueed up nice. I loaded a snap cap and it feeds and ejects great. All I got to do now is check the headspace. This won't be for a while though. The go nogo gages are like 62.00 USD at Brownells. I just can't afford this right now and if I need a reamer, oh boy another 70 bucks. I been spending a lot lately on gun stuff and the wife is starting to get a little upset........hehe. Oh well I'll just have to look at it, take the clip in and out, in and out, load and eject the snap caps. Man......I want to shoot it!!! Here are more pics: