Identification of DWM Luger

Norme · 05-13-2012, 02:47 PM

Hi Dave, Forgive me for asking another obvious question. Have you cleaned this gun? Specifically, have you scrubbed out the bore with a bronze brush and a solvent like Hoppes #9? The chamber on 9mm Lugers is constricted near the end (it appears as a ring when you peer into the chamber), and is intended to form a gas tight seal. Your chamber may be fouled up. Good luck! Norm

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-13-2012, 02:47 PM	#16
Norme Always A Lifetime Forum Patron Join Date: Jul 2009 Location: Colorado Posts: 2,417 Thanks: 226 Thanked 2,607 Times in 933 Posts	Hi Dave, Forgive me for asking another obvious question. Have you cleaned this gun? Specifically, have you scrubbed out the bore with a bronze brush and a solvent like Hoppes #9? The chamber on 9mm Lugers is constricted near the end (it appears as a ring when you peer into the chamber), and is intended to form a gas tight seal. Your chamber may be fouled up. Good luck! Norm