Mark D's Luger Rust Blue Solution and Refinishing Tips Article

markbritt · 12-01-2011, 09:03 PM

Jerry and Bob (nukem556):

You point about the water is a valid one. I live in NW Indiana, but have well water. Being close to the Lake Michigan basin, we have very good water, but it does get a bit nasty at times. I run both a water filter and a Kinetico water softener to remove most of the iron and sulphur traces. Initially I did use distilled water, but found no difference between using that and my well water, but I think I was very lucky.

That said, I would definitely agree that going with distilled water would save you a lot of heartache!

Mark D

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-01-2011, 09:03 PM	#1
markbritt User Join Date: Oct 2009 Location: NW Indiana Posts: 240 Thanks: 5 Thanked 48 Times in 22 Posts	Jerry and Bob (nukem556): You point about the water is a valid one. I live in NW Indiana, but have well water. Being close to the Lake Michigan basin, we have very good water, but it does get a bit nasty at times. I run both a water filter and a Kinetico water softener to remove most of the iron and sulphur traces. Initially I did use distilled water, but found no difference between using that and my well water, but I think I was very lucky. That said, I would definitely agree that going with distilled water would save you a lot of heartache! Mark D