1910 DWM P08. what parts should be strawed?

lugerholsterrepair · 11-19-2011, 11:19 AM

Christian, Welcome to the Luger Forum!

Yes..You need to clean the parts with a good solvent to remove any grease or oils..even from your fingers when handeling.

It is not necessary to bury the parts in sand. Just lay them on a small tray.

The parts must stay in the oven untill it reaches the correct temperature. The books say once parts are correct..remove them and put oil on them as they may continue to heat from the soak. It's all easier than you think!

11-19-2011, 11:19 AM	#7
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Christian, Welcome to the Luger Forum! Yes..You need to clean the parts with a good solvent to remove any grease or oils..even from your fingers when handeling. It is not necessary to bury the parts in sand. Just lay them on a small tray. The parts must stay in the oven untill it reaches the correct temperature. The books say once parts are correct..remove them and put oil on them as they may continue to heat from the soak. It's all easier than you think! __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode