Feedback on my 1st. Luger

alanint · 07-06-2011, 07:29 AM

As you mention, you have a VOPO Luger with the plastic, Bullseye grips that someone took apart, apparently to refinish/restore.
The wire in the second photo is the spring that holds the takedown lever, (locking bolt) in place. You will see a cut under where the takedown lever fits. This is where this spring drops into. There is a corresponding hole in the frame in front of the triggerguard where the small end of the spring is anchored.

07-06-2011, 07:29 AM	#2
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	As you mention, you have a VOPO Luger with the plastic, Bullseye grips that someone took apart, apparently to refinish/restore. The wire in the second photo is the spring that holds the takedown lever, (locking bolt) in place. You will see a cut under where the takedown lever fits. This is where this spring drops into. There is a corresponding hole in the frame in front of the triggerguard where the small end of the spring is anchored. Last edited by alanint; 07-06-2011 at 09:33 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode