Question on barrel replacement ...

[G.T.]

Hi To all, and Hi Hugh! Thanks for you post..... after a few hours with the digital caliper, I found out the following... The barrel I'm using hand tightens up to exactly the same extractor width distance desired by hand on three different receivers... 1920 commercial, 1920/ model 08 commercial navy, and 1917 DWM WW1 receiver... The receiver in question, 1916 navy, measures exactly the same in all regards, within .0015" everywhere... and with the very same barrel, probably 190 to 200 degrees from straight up tight... probably 180 degrees from desired position at hand tight.. So, it apperas thet I'll have to shave the shoulder, shave the barrel breech end, and deepen the chamber / headspace... Sooooo, it apprears a finish reamer, and a "go" and "no go" gauge(s) are in the future purchases or trades list... any of you guys got any spares you're willing to let go... I've got trade bait coming and going all the time!!...... Thanks guys, this is really staring to get fun now... Now I can actually screw my own stuff up!...... Might be time to make a barrel also... we'll see.. best to all, til...lat'r....GT