Question on barrel replacement ...

Ron Wood · 05-28-2011, 07:59 PM

There you go! Somebody that knows what they are talking about. I repeat, I don't do thousandths well

!

sheepherder · 05-28-2011, 08:14 PM

Quote:

Originally Posted by Ron Wood

There you go! Somebody that knows what they are talking about. I repeat, I don't do thousandths well

!

"Gunsmithing" via forum posts is like diagnosing what's wrong with your car over the telephone...

There's a lot of variables at work here...Were the threads cleaned; were they lightly lubed; were there any dings; any caked crap on threads/flange faces; had it been cut down before; is it 'original' or a repro; did the 'smith' torque it down three times to 'set' the threads; is it a really tight (or loose) fit; etc...

Too many variables for any quick & easy solution...

...My $.02...Ka-Ching!!!...

G.T. · 05-28-2011, 08:52 PM

Hi Guys, thanks for all, I'm going to measure out a few things before I proceed... But, it's not at the flange area where the interferance is occuring.. it's at the very most back part of the barrel bottoming out in the receiver, (at the rails??) So, it would appear that the receiver is overall too short... but it doesn't apperar altered???.. Stacking thousands??, or just wrong end of the plus tolerances's??.. Annnnddd, somewhere along the line, I'm going to have to buy or make a headspace gauge... Woe is me....

... but the challenge is eagerly met, ...

... Thanks guys, best to you all, til...lat'r...GT

05-28-2011, 07:59 PM	#1
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,257 Times in 1,724 Posts	There you go! Somebody that knows what they are talking about. I repeat, I don't do thousandths well ! __________________ If it's made after 1918...it's a reproduction

05-28-2011, 08:52 PM	#3
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,528 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	measurements needed! Hi Guys, thanks for all, I'm going to measure out a few things before I proceed... But, it's not at the flange area where the interferance is occuring.. it's at the very most back part of the barrel bottoming out in the receiver, (at the rails??) So, it would appear that the receiver is overall too short... but it doesn't apperar altered???.. Stacking thousands??, or just wrong end of the plus tolerances's??.. Annnnddd, somewhere along the line, I'm going to have to buy or make a headspace gauge... Woe is me....... but the challenge is eagerly met, ...... Thanks guys, best to you all, til...lat'r...GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode