Question on barrel replacement ...

G.T. · 05-28-2011, 07:52 PM

OK guys! Barrel removal is a snap... The rosin was just the ticket and my receiver wrench is work'en great... so, now I try to screw in an original barrel from another receiver, aaaannnndddd, it actually hits / bottoms out, on the receiver at / on, the breech face end of the barrel, leaving the flange about half a turn out...???....

... Is this abnormal, un-usual, or just beginners luck!

..... Best to all, til...lat'r...GT

05-28-2011, 07:52 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,540 Thanks: 1,342 Thanked 3,735 Times in 1,019 Posts	Here's where we're at! OK guys! Barrel removal is a snap... The rosin was just the ticket and my receiver wrench is work'en great... so, now I try to screw in an original barrel from another receiver, aaaannnndddd, it actually hits / bottoms out, on the receiver at / on, the breech face end of the barrel, leaving the flange about half a turn out...???....... Is this abnormal, un-usual, or just beginners luck!..... Best to all, til...lat'r...GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode