LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Repairs, Restoration & Refinishing

Reply
 
Thread Tools Display Modes
Unread 04-25-2011, 12:22 PM   #1
John Sabato
Lifer
Lifetime Forum
Patron
 
John Sabato's Avatar
 
Join Date: Jun 2002
Location: The Capital of the Free World
Posts: 10,156
Thanks: 3,003
Thanked 2,308 Times in 1,098 Posts
Default

Alanint is correct that this roller solution will only work for a barrel with a straight (no taper dimension)... While I am sure a tool could be designed that would work on a taper, it would not be a hand held device.

The rollers on such a tool would have to float longitudinally (adjust themselves) to the taper of the barrel to prevent galling the exterior dimensions and at the same time be able to be held stationary while they accomplished their task. The natural tendency of the tool would be to walk with the taper as the tool was tightened. This movement would have to be prevented, and the rollers would have to be longer in length than overall length of the bulged section of the barrel in order to do a reasonably good job. In this particular case, a tool such as that which was described by Postino just might work, because if memory serves me correctly, this is not a tapered barrel? Can anyone confirm this, because I don't own one of these pistols. I personally have always thought that they were pretty ugly, but then I am a Luger enthusiast, and pretty much all other pistols are ugly!

This process has been successfully used to reshape bulged shotgun barrels using a mandrel inside the barrel to prevent collapse during the rolling... In this case a mandrel or rod that was exactly the land diameter would be used to prevent the reshaping of the barrel from going too far. This would be very similar to how hammer forged barrels are made in the first place. We aren;t talking about a great deal of displacement of metal here, cause if we were, the repair would not even be feasible.

The key to being able to effect this repair is whether or not the barrel is too bulged to be repaired in the first place.

FNorm, the pistol is described as a 1914/34 (Mauser?) which would be .32 ACP, and not 9mm.

Since Jim is already talking about rebluing the gun, It is likely not a collectible, and I believe that he just wants it to be safely functional.

I think the easiest and probably the most inexpensive course of action would be to obtain a used replacement barrel and be done with it.
__________________
regards, -John S

"...We hold these truths to be self-evident that ALL men are created EQUAL and are endowed by their Creator with certain UNALIENABLE rights, and among these are life, LIBERTY, and the pursuit of happiness..."
John Sabato is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:09 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Lugerforum.com