Converting a .30 to a 9mm

John Sabato · 02-08-2011, 09:52 AM

Not only was Rich (Postino) not mocking anyone... I would say that someone who was properly equipped to make barrel changes would not take longer than about 3 minutes to do a barrel change. The key phrase here is "properly equipped"... you absolutely MUST have the right tools if you hope to NOT harm your gun or barrels.
Here is a link to one of Rich's photo albums that show all the necessary tools for changing a Luger barrel without damaging the receiver or the new barrel... This is not a job for the UNDER-equipped gun tinkerer... You must have the tools---OR don't try this at home kids!

http://forum.lugerforum.com/album.ph...pictureid=1556

02-08-2011, 09:52 AM	#7
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	Not only was Rich (Postino) not mocking anyone... I would say that someone who was properly equipped to make barrel changes would not take longer than about 3 minutes to do a barrel change. The key phrase here is "properly equipped"... you absolutely MUST have the right tools if you hope to NOT harm your gun or barrels. Here is a link to one of Rich's photo albums that show all the necessary tools for changing a Luger barrel without damaging the receiver or the new barrel... This is not a job for the UNDER-equipped gun tinkerer... You must have the tools---OR don't try this at home kids! http://forum.lugerforum.com/album.ph...pictureid=1556 __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode