Luger gunsmith

[Lugerdoc]

Don't forget to check that EJECTOR. The best price that I found for new repro LPO8 shoulder stocks is from Numrich. TH

[Marine 3]

Thanks Doc, The more I think about it, I believe the ejector may be what is wrong.
I will check Numrich about the stock

[Marine 3]

Originally Posted by Lugerdoc

Don't forget to check that EJECTOR. The best price that I found for new repro LPO8 shoulder stocks is from Numrich. TH

Doc,
I just field stripped the Luger and checked the ejector like you said to see that it was moving freely and not binding. All looked good to me! It pushed out with firm finger pressure and went back to position under its spring action when released. It did not appear to be binding anywhere. This is my opinion, you might see something amiss because of your Luger experience.
I will put in the new springs when they come and see if the extractor action works better.
I did notice that the extractor spring was hard to pull out of the hole it was in. Also hard to get back in when I assembled it. I would think that fit should have been more loose ??
Marine 3