Luger gunsmith

Marine 3 · 02-02-2011, 03:42 PM

I have covered the bases that you boys have sugested with no apparent improvement in the extaction function. The pistol will fire, extract and eject just fine for two to three rounds and then hang up with the empty case half out of the chamber and the bolt to the rear trying to pick up the next round out of the magazine. I thought it somehow might be the magazine, so I fired the pistol by single shot loading with no mag. It will function OK for about half the shots and then hang up as I have described. I have used two diferent mags and both 115 and 124 grain bullets. I reload so I have used both Winchester commercial loads and a hotter 124 grain bullet handload.
This pistol has been rebarreled and I wonder if that could be a factor.
Before this last test firing, I took out the extractor and cleaned under it and tried to stretch the spring a little. There was almost no dirt under the extractor to begin with. The ejector seemed to be in good shape.
I am open to any more ideas and suggestions.
Thanks for your interest
Marine 3

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-02-2011, 03:42 PM	#23
Marine 3 User Join Date: Jan 2011 Posts: 23 Thanks: 1 Thanked 4 Times in 1 Post	I have covered the bases that you boys have sugested with no apparent improvement in the extaction function. The pistol will fire, extract and eject just fine for two to three rounds and then hang up with the empty case half out of the chamber and the bolt to the rear trying to pick up the next round out of the magazine. I thought it somehow might be the magazine, so I fired the pistol by single shot loading with no mag. It will function OK for about half the shots and then hang up as I have described. I have used two diferent mags and both 115 and 124 grain bullets. I reload so I have used both Winchester commercial loads and a hotter 124 grain bullet handload. This pistol has been rebarreled and I wonder if that could be a factor. Before this last test firing, I took out the extractor and cleaned under it and tried to stretch the spring a little. There was almost no dirt under the extractor to begin with. The ejector seemed to be in good shape. I am open to any more ideas and suggestions. Thanks for your interest Marine 3