P08 Frame Abutment Projections???

lfid · 01-28-2011, 12:39 PM

my guess is that these little ears were used for either some manufacturing tool / gauge attachment or perhaps were intended to be used as a check that the rear machining was symmetrical

it doesnt seem they align anything after assembly or provide a final flip up method for the toggle rear link underside - and they look too fragile to do much anyway - might even be a hazard to shooters face if ever touched by toggle operation like the worn lugers that rear of breechblock show some impact to that area

anybody ever seen a frame with little ear(s) broken off ?

good question !!!
Bill

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-28-2011, 12:39 PM	#3
lfid Lifer Lifetime Forum Patron Join Date: Sep 2006 Location: Wichita, KS USA Posts: 453 Thanks: 573 Thanked 96 Times in 53 Posts	my guess is that these little ears were used for either some manufacturing tool / gauge attachment or perhaps were intended to be used as a check that the rear machining was symmetrical it doesnt seem they align anything after assembly or provide a final flip up method for the toggle rear link underside - and they look too fragile to do much anyway - might even be a hazard to shooters face if ever touched by toggle operation like the worn lugers that rear of breechblock show some impact to that area anybody ever seen a frame with little ear(s) broken off ? good question !!! Bill