1915 4inch artillery luger /??? PICS...

Lugerdoc · 12-10-2010, 12:27 PM

I've seen a couple 4" "LPO8" before and alway thought that the conversion might be a result of a bulge in the area that was removed. I've also seen many 7&1/2" barrelled LPO8 where the barrel was cut off just aft of the front sight base, most likely due to a frozen up fine tune front sight, and a fixed C96 sight was installed. I do have a few of these barrels with exc bores available, but i'm sold out of both orig & new repro 8" LPO8 barrels. Finally, I did once owe a "left hand" pattern home made (or Brenner pass special) 16+" barrelled non-self loading luger in .30 Carbine caliber. The barrelled receiver was fixed and you had to pull back the toggle to load the next round. TH

12-10-2010, 12:27 PM	#1
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	I've seen a couple 4" "LPO8" before and alway thought that the conversion might be a result of a bulge in the area that was removed. I've also seen many 7&1/2" barrelled LPO8 where the barrel was cut off just aft of the front sight base, most likely due to a frozen up fine tune front sight, and a fixed C96 sight was installed. I do have a few of these barrels with exc bores available, but i'm sold out of both orig & new repro 8" LPO8 barrels. Finally, I did once owe a "left hand" pattern home made (or Brenner pass special) 16+" barrelled non-self loading luger in .30 Carbine caliber. The barrelled receiver was fixed and you had to pull back the toggle to load the next round. TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode