Having some difficulty with reassembly

Railsplitter · 11-26-2010, 06:29 PM

It almost sounds like you are pulling the toggle assembly back too far. Just lift the knurled rings up off the receiver until the breach opens, what is it guys about 2 or 3 millimeters ?? and hold it there. Then squeeze the trigger and hold it back. Then settle the knurled rings back down on the receiver which will close the breach. Then release the trigger. That should do it. And please, as noted by the other members, no live rounds in the neighborhood!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-26-2010, 06:29 PM	#12
Railsplitter User Join Date: Jun 2002 Location: Chandler, AZ Posts: 112 Thanks: 0 Thanked 13 Times in 11 Posts	It almost sounds like you are pulling the toggle assembly back too far. Just lift the knurled rings up off the receiver until the breach opens, what is it guys about 2 or 3 millimeters ?? and hold it there. Then squeeze the trigger and hold it back. Then settle the knurled rings back down on the receiver which will close the breach. Then release the trigger. That should do it. And please, as noted by the other members, no live rounds in the neighborhood!