Banner stamp error or irregularity

alanint · 08-20-2010, 12:06 PM

The argument against an older marking having been scrubbed off is that this would have also affected the matching part number. In this case the top of the toggle surface is perfectly even with a deep number stamped. This would not be the case if they had removed any metal forward of the part number.

I say factory mistake, which is suble enough to have been missed by QC.

(I don't think any inspector anywhere looks at gun markings more minutely than this crowd! 8^)

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

08-20-2010, 12:06 PM	#1
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	The argument against an older marking having been scrubbed off is that this would have also affected the matching part number. In this case the top of the toggle surface is perfectly even with a deep number stamped. This would not be the case if they had removed any metal forward of the part number. I say factory mistake, which is suble enough to have been missed by QC. (I don't think any inspector anywhere looks at gun markings more minutely than this crowd! 8^)