Whats it worth? My 1st Luger (rig) purchase

[Sieger]

Originally Posted by LugerVern

Attached is a picture of your guns right trigger guard ( on left) and another byf41 in the center for comparison

Your gun shows obvious signs of rounding of edges from the over use of a buffing wheel. It covers most of the upper trigger guard and extends into the grip area and also has widened the take down hole.

I don't really pay much attention to grips, but we did identify after market grips being produced about a year ago that look just like yours, they came cut short and poorly cut for the safety lever.

I hope you did not pay too much for your gun.

Best of luck and thanks for posting

Vern

Vern:

Thanks for the close-up of the grip. This is not an original grip!!!

Sieger

[bijj62]

Originally Posted by Sieger

Vern:

Thanks for the close-up of the grip. This is not an original grip!!!

Sieger

How do you figure?

[Norme]

Hi Jason, Welcome to "The Luger Forum"! I know you must think that your welcome so far has been far from friendly, but you should understand that sharing knowledge and experience, and critiquing guns is what this forum is all about. That said, I think your gun, including grips, is all original, and the "softening" observed is merely the result of soft photos. Best regards, Norm

[bijj62]

Originally Posted by norme

hi jason, welcome to "the luger forum"! I know you must think that your welcome so far has been far from friendly, but you should understand that sharing knowledge and experience, and critiquing guns is what this forum is all about. That said, i think your gun, including grips, is all original, and the "softening" observed is merely the result of soft photos. Best regards, norm

thank you!!