Locking Bolt Spring Trouble

John Sabato · 04-12-2010, 03:58 PM

The little end of the "L" shaped spring goes through the hole in the frame and will protrude slightly. The long end lies in the recess at the bottom of the takedown lever hole and the bump in that spring leg fits into a recess on the bottom of the takedown lever...

This is hard to explain without photos, but I don't have access to my photo library from here.

Perhaps this answer can be found on the YOUTUBE videos on Luger disassembly that have been generously posted there by one of our members...

kingpin93 · 04-12-2010, 04:11 PM

I have checked out the videos on youtube, but I could not find one that showed any detail of the spring and its placement.

04-12-2010, 03:58 PM	#1
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,309 Times in 1,098 Posts	The little end of the "L" shaped spring goes through the hole in the frame and will protrude slightly. The long end lies in the recess at the bottom of the takedown lever hole and the bump in that spring leg fits into a recess on the bottom of the takedown lever... This is hard to explain without photos, but I don't have access to my photo library from here. Perhaps this answer can be found on the YOUTUBE videos on Luger disassembly that have been generously posted there by one of our members... __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

04-12-2010, 04:11 PM	#2
kingpin93 New User Join Date: Apr 2010 Posts: 3 Thanks: 1 Thanked 0 Times in 0 Posts	Thanks I have checked out the videos on youtube, but I could not find one that showed any detail of the spring and its placement.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode