Is there a Broomhandle Doctor in the Haus? - Runs Good!

azlaw · 03-27-2010, 11:25 PM

Found the problem, it was visible in the photos I posted - the sear was not properly fitted to the pistol, and was not able to sufficiently engage the hammer. Just had to stone the bottom of the sear a bit to allow it to drop to the sear stop - you can see how much space there was before. I agree that the disconnector/sear arm spring enagement looks a bit flakey, but it doesn't come off and appears to do its job.

The pistol works fine now.

03-27-2010, 11:25 PM	#11
azlaw User Join Date: Mar 2007 Location: Tucson, AZ Posts: 207 Thanks: 1 Thanked 4 Times in 4 Posts	Found the problem, it was visible in the photos I posted - the sear was not properly fitted to the pistol, and was not able to sufficiently engage the hammer. Just had to stone the bottom of the sear a bit to allow it to drop to the sear stop - you can see how much space there was before. I agree that the disconnector/sear arm spring enagement looks a bit flakey, but it doesn't come off and appears to do its job. The pistol works fine now. Last edited by azlaw; 03-28-2010 at 01:13 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode