Free up relic luger

02tobbe · 03-19-2010, 08:19 AM

Still no success in getting the barrel section and receiver to separate ;( I have been soaking it with severeal cans of WD40 and pounding on it but no go. I have even tried a special rust solvent that cools down the rust to -40 C to crack the rust and then penetrate it with the rust solvent, but that didn´t work either.

I guess that the small tolerances of the luger makes it hard for the solvent to penetrate enough to get to the rust.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-19-2010, 08:19 AM	#1
02tobbe User Join Date: Mar 2010 Posts: 19 Thanks: 0 Thanked 0 Times in 0 Posts	Still no success in getting the barrel section and receiver to separate ;( I have been soaking it with severeal cans of WD40 and pounding on it but no go. I have even tried a special rust solvent that cools down the rust to -40 C to crack the rust and then penetrate it with the rust solvent, but that didn´t work either. I guess that the small tolerances of the luger makes it hard for the solvent to penetrate enough to get to the rust.