Luger Build Progress

Edward Tinker · 09-03-2009, 03:04 PM

if its completely apart, tehre are soem tricks that I can throw out ahead of time.

1. The safety lever and pin, drive from down to up, us some needle nose pliers to half way hold in place and then tap, tap tap
2. The damn action spring (thats a wrong term, but my mind is blank); it will be a bear, wear glasses and be in a smalelr area, it will go boooooing and be hard to find if you do it in a shop or other "busy" area. I have a tool I bought from a member here that holds the end retainer with a sharpened screw driver and then has leverage. Without this, use your needle nose and against a table you don't mind denting and scratching
3. take your time, but most parts go in easily.

Ed

09-03-2009, 03:04 PM	#2
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,974 Thanks: 2,072 Thanked 4,607 Times in 2,123 Posts	if its completely apart, tehre are soem tricks that I can throw out ahead of time. 1. The safety lever and pin, drive from down to up, us some needle nose pliers to half way hold in place and then tap, tap tap 2. The damn action spring (thats a wrong term, but my mind is blank); it will be a bear, wear glasses and be in a smalelr area, it will go boooooing and be hard to find if you do it in a shop or other "busy" area. I have a tool I bought from a member here that holds the end retainer with a sharpened screw driver and then has leverage. Without this, use your needle nose and against a table you don't mind denting and scratching 3. take your time, but most parts go in easily. Ed __________________ Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode