Commercial Luger ID Mystery

LugerVern · 06-04-2009, 11:25 PM

Hi Clark

This may be nothing but if you would like to continue; I would be interested in taking a measurement on the receiver lug height.

The receiver lug is often stamped with a partial SN, this is usually very deep, one of the things to check for is to see if the SN has been removed and in the process the height of the lug lowered.

This is a very often over looked detail and should be part of the review prior to purchase, especially of the more expensive guns.

The diagram is a small part of one picture from John Sabatoâ??s â??Luger Blueprint CDâ? that is available for sale in the for sale part of this forum. It has saved me a lot of money and I highly recommend it to everyone.

John, hope you donâ??t mind me using it as an example?

Vern

06-04-2009, 11:25 PM	#19
LugerVern User Join Date: Apr 2005 Location: Virginia Posts: 563 Thanks: 1 Thanked 34 Times in 27 Posts	Hi Clark This may be nothing but if you would like to continue; I would be interested in taking a measurement on the receiver lug height. The receiver lug is often stamped with a partial SN, this is usually very deep, one of the things to check for is to see if the SN has been removed and in the process the height of the lug lowered. This is a very often over looked detail and should be part of the review prior to purchase, especially of the more expensive guns. The diagram is a small part of one picture from John Sabatoâ??s â??Luger Blueprint CDâ? that is available for sale in the for sale part of this forum. It has saved me a lot of money and I highly recommend it to everyone. John, hope you donâ??t mind me using it as an example? Vern Attached Thumbnails

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode