Taper Crimp?

Sieger · 05-09-2009, 04:29 AM

PhilOhio:

For the 9mm, I have had great success with the new Hornady carbide dies.

For FMJ, I use the standard expander, whereas, for lead, I use the expander they sell for the .38 Super. This combination seems to do the trick perfectly.

Yes, by all means, use a carbide set, as it eliminates the need for all most all lubrication.

I'd be interested in the exact loads you have developed, as I have been perfecting loads for the Luger since about 1978.

Lugers will operate perfectly with a proper set of springs and correctly crafted ammo.

Hope to hear about those loads!!

Sieger

05-09-2009, 04:29 AM	#8
Sieger User Join Date: Jul 2003 Location: New York, NY Posts: 1,579 Thanks: 2,154 Thanked 402 Times in 251 Posts	PhilOhio: For the 9mm, I have had great success with the new Hornady carbide dies. For FMJ, I use the standard expander, whereas, for lead, I use the expander they sell for the .38 Super. This combination seems to do the trick perfectly. Yes, by all means, use a carbide set, as it eliminates the need for all most all lubrication. I'd be interested in the exact loads you have developed, as I have been perfecting loads for the Luger since about 1978. Lugers will operate perfectly with a proper set of springs and correctly crafted ammo. Hope to hear about those loads!! Sieger Last edited by Sieger; 05-09-2009 at 05:41 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode