Taper Crimp?

PhilOhio · 05-08-2009, 09:25 PM

Sieger,

I pretty much agree with what you say. I also try to do what you refer to as "micro belling"; I would prefer not to bell at all, so I do the minimum necessary to let ram pressure seat the bullet without shaving lead.

It's all about fun, and I really enjoy reloading. I've spent the whole week working up loads for my newly acquired 1937 S/42 Luger, and finally have it licked; reliable functioning; and with much less powder than expected.

But just this evening I learned something new about taper crimping (or maybe not having to taper crimp, I hope). While ordering some Lee parts, I learned that they claim their new generation of pistol dies are made to such tolerances THAT NO TAPER CRIMPING IS REQUIRED on cartridges such as 9mm Para, etc. They say the powder die puts on a minimum bell, and the seating die is made so it removes even this...and, I guess ends up with a very tight bullet fit, having the effect of a taper crimp.

I've been using other non-Lee dies for 9mm, such as RCBS or Lyman. For those, I still feel it is prudent to taper crimp.

BUT...

I also have a Lee carbide set in 9mm. So maybe that one is the way to go; eliminate case lubing and taper crimping, and test the result for awhile, to see how it works out. Easier is always better, if the result is acceptable.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-08-2009, 09:25 PM	#7
PhilOhio User Join Date: Apr 2009 Location: Ohio Posts: 145 Thanks: 5 Thanked 17 Times in 14 Posts	Sieger, I pretty much agree with what you say. I also try to do what you refer to as "micro belling"; I would prefer not to bell at all, so I do the minimum necessary to let ram pressure seat the bullet without shaving lead. It's all about fun, and I really enjoy reloading. I've spent the whole week working up loads for my newly acquired 1937 S/42 Luger, and finally have it licked; reliable functioning; and with much less powder than expected. But just this evening I learned something new about taper crimping (or maybe not having to taper crimp, I hope). While ordering some Lee parts, I learned that they claim their new generation of pistol dies are made to such tolerances THAT NO TAPER CRIMPING IS REQUIRED on cartridges such as 9mm Para, etc. They say the powder die puts on a minimum bell, and the seating die is made so it removes even this...and, I guess ends up with a very tight bullet fit, having the effect of a taper crimp. I've been using other non-Lee dies for 9mm, such as RCBS or Lyman. For those, I still feel it is prudent to taper crimp. BUT... I also have a Lee carbide set in 9mm. So maybe that one is the way to go; eliminate case lubing and taper crimping, and test the result for awhile, to see how it works out. Easier is always better, if the result is acceptable.