Unusual Holster Marking

lugerholsterrepair · 02-07-2009, 09:47 PM

Robert, Your closure stud seems to be of the standard size..what I would expect. I have never seen the large studs on anything but 1934's.
I have found many holsters have the closure flap of the tool pouch cut short when the jag pouch is installed. This is because... as Alinint says..the closure straps are too thick for the small stud.
Yours was probably removed altogether and the long cleaning rod strap was used to hold both the rod and the tool. It would not be adequate to hold in a tool that fit loosely in my opinion. Most tools fit tightly though so it was likely not a problem.

Jerry Burney

02-07-2009, 09:47 PM	#1
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Robert, Your closure stud seems to be of the standard size..what I would expect. I have never seen the large studs on anything but 1934's. I have found many holsters have the closure flap of the tool pouch cut short when the jag pouch is installed. This is because... as Alinint says..the closure straps are too thick for the small stud. Yours was probably removed altogether and the long cleaning rod strap was used to hold both the rod and the tool. It would not be adequate to hold in a tool that fit loosely in my opinion. Most tools fit tightly though so it was likely not a problem. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode