What is the influence of overal length?

alterfritz · 02-05-2009, 03:50 PM

Yep, I don't know which load they used of course. It was the original magazine that came with the gun, but then the second magazine has a little dent to it too. I currently have two mec gear magazines with GT, from what I read elsewhere int he forum they should do a good job after the springs and bottoms have been exchanged.
I'm not so much puzzled about the round in the chamber because that was actually in the correct place but the magazine somehow was stuck and needed some force to pull it out. Thanks for the advice though, I will wait for the two magazines and see how they do with winchester ammonition

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-05-2009, 03:50 PM	#5
alterfritz User Join Date: Nov 2008 Location: California Posts: 63 Thanks: 3 Thanked 3 Times in 3 Posts	Yep, I don't know which load they used of course. It was the original magazine that came with the gun, but then the second magazine has a little dent to it too. I currently have two mec gear magazines with GT, from what I read elsewhere int he forum they should do a good job after the springs and bottoms have been exchanged. I'm not so much puzzled about the round in the chamber because that was actually in the correct place but the magazine somehow was stuck and needed some force to pull it out. Thanks for the advice though, I will wait for the two magazines and see how they do with winchester ammonition