Considering a 1970's Mauser American Eagle...

lfid · 01-18-2009, 03:27 PM

Vlim,

thanks !!! for the excellent pictures and info

so it looks like all that is needed is just to cut off the palm safety and stub to it from the internal bar part - almost too easy

should be a lot easier than adapting the frame slot to a dwm P08 sear bar block

and I suppose one could cut the palm part off and polish the metal + blue to fill / match up with the grip slot when in safe position

mine has the grip pins and is P08 type frame - so far about 200 rounds with a few eject problems

now if I can resolve the rear target sight and bull barrel problem , could finally have a simulated target MP

rear target sight and barrel ( long barrel extension type ) seem to be elusive problems to resolve here in usa

have you seen any of the Rettinger in Germany made target lugers ?

thanks again for the info

Bill

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-18-2009, 03:27 PM	#28
lfid Lifer Lifetime Forum Patron Join Date: Sep 2006 Location: Wichita, KS USA Posts: 453 Thanks: 573 Thanked 96 Times in 53 Posts	Vlim, thanks !!! for the excellent pictures and info so it looks like all that is needed is just to cut off the palm safety and stub to it from the internal bar part - almost too easy should be a lot easier than adapting the frame slot to a dwm P08 sear bar block and I suppose one could cut the palm part off and polish the metal + blue to fill / match up with the grip slot when in safe position mine has the grip pins and is P08 type frame - so far about 200 rounds with a few eject problems now if I can resolve the rear target sight and bull barrel problem , could finally have a simulated target MP rear target sight and barrel ( long barrel extension type ) seem to be elusive problems to resolve here in usa have you seen any of the Rettinger in Germany made target lugers ? thanks again for the info Bill