S Link noise

lugerholsterrepair · 01-02-2009, 01:24 PM

Herr MCNJ So pushing fully back on the cannon activates a locking mech?

No..When you put the top cannon onto the pistol and slide it towards the back you can observe the toggle connecting link slip UNDER the hook of the main spring. Sliding back the cannon and pushing on the muzzle firmly connects these two under tension. If they are NOT connected you should know immediately as the toggle will be loose and often will break upwards as there is no link to the mainspring to prevent it.
You can disassemble the pistol and reassemble it without pushing the top cannon back. I just tried it. It's more difficult to do however.

Jerry Burney

01-02-2009, 01:24 PM	#16
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Herr MCNJ So pushing fully back on the cannon activates a locking mech? No..When you put the top cannon onto the pistol and slide it towards the back you can observe the toggle connecting link slip UNDER the hook of the main spring. Sliding back the cannon and pushing on the muzzle firmly connects these two under tension. If they are NOT connected you should know immediately as the toggle will be loose and often will break upwards as there is no link to the mainspring to prevent it. You can disassemble the pistol and reassemble it without pushing the top cannon back. I just tried it. It's more difficult to do however. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode