S Link noise

MCNJ · 01-02-2009, 12:05 PM

Ron
I went through the motions, but can't see exactly what was wrong. The s link was dropped forward of the recoil.
It is all tight now and operates.

The only thing I noticed ( and I watched the video 3 times ) was that before putting the side plate on.....when I put the mag in and pulled the action up, the top end slid on the frame. I finally pushed it as far back as it could go and it "seemed to lock it". I was then able to install the side plate and it seems fine.

Does that final push back of the top end on the frame lock the s-link?? And if I did not do that the 1st time, could that have caused it??

Any ideas ?? Am I noticing some wear??

MCNJ · 01-02-2009, 12:08 PM

Thanks John and Jerry.........I did not see your reply when I responded.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

01-02-2009, 12:05 PM	#1
MCNJ User Join Date: Jul 2008 Location: NJ USA Posts: 62 Thanks: 5 Thanked 1 Time in 1 Post	Ron I went through the motions, but can't see exactly what was wrong. The s link was dropped forward of the recoil. It is all tight now and operates. The only thing I noticed ( and I watched the video 3 times ) was that before putting the side plate on.....when I put the mag in and pulled the action up, the top end slid on the frame. I finally pushed it as far back as it could go and it "seemed to lock it". I was then able to install the side plate and it seems fine. Does that final push back of the top end on the frame lock the s-link?? And if I did not do that the 1st time, could that have caused it?? Any ideas ?? Am I noticing some wear??

01-02-2009, 12:08 PM	#2
MCNJ User Join Date: Jul 2008 Location: NJ USA Posts: 62 Thanks: 5 Thanked 1 Time in 1 Post	Thanks John and Jerry.........I did not see your reply when I responded.