Engraved artillery luger

alvin · 12-28-2008, 08:02 PM

Welcome to the forum.

I noticed there are three common ways to 'promote' a pistol. The most common way is to refurbish it. The 2nd way is to engrave it. The 3rd way is to cut it away to make a arsenal classroom gun. The latter two ways are usually applied on mismatched pistols....the 3rd way is the coolest -- just cut the mismatched number out of the picture

Both engraving and cut away take lots of effort so they are usually not cheap when you buy them.

The grip panels are very unique.

DaveinTN · 12-28-2008, 09:53 PM

Van,

I thought for a second you had one of these, but apparently you don't. For a good laugh, check out the photo below. Makes Mitchell look like nothing.....

12-28-2008, 09:53 PM	#2
DaveinTN User Join Date: Nov 2006 Location: Tennessee Posts: 186 Thanks: 3 Thanked 15 Times in 11 Posts	Van, I thought for a second you had one of these, but apparently you don't. For a good laugh, check out the photo below. Makes Mitchell look like nothing..... Attached Images

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-28-2008, 08:02 PM	#1
alvin User Join Date: Jul 2007 Location: US Posts: 3,843 Thanks: 132 Thanked 729 Times in 438 Posts	Welcome to the forum. I noticed there are three common ways to 'promote' a pistol. The most common way is to refurbish it. The 2nd way is to engrave it. The 3rd way is to cut it away to make a arsenal classroom gun. The latter two ways are usually applied on mismatched pistols....the 3rd way is the coolest -- just cut the mismatched number out of the picture Both engraving and cut away take lots of effort so they are usually not cheap when you buy them. The grip panels are very unique.