"New" Luger Issues

jonnyc · 12-13-2008, 08:58 PM

1. Some fitting to the take-down lever has that working acceptably.
2. A hold-open spring, new Mecgar mag, and some wooden grips are on the way from Lugerdoc.
3. I did the tigger-lever/disconnector plunger modification I found on the site.
4. I re-fitted the safety lever pin and did the "bending" operation I also found here, that's acceptably tight now.
5. Discovered that the chromed "INTERARMS" mag that came with the pistol is actually a Mecgar.
6. I removed the hold-open pending receipt of the spring.
7. Tomorrow we're going to the range to try some WWB, Chinese 124gr., and some 1950s Canadian "CIA" mil-surp ammo.
It's been a productive week. I hope some of the work paid off and I can report some success!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-13-2008, 08:58 PM	#5
jonnyc User Join Date: Dec 2008 Posts: 425 Thanks: 2 Thanked 46 Times in 34 Posts	1. Some fitting to the take-down lever has that working acceptably. 2. A hold-open spring, new Mecgar mag, and some wooden grips are on the way from Lugerdoc. 3. I did the tigger-lever/disconnector plunger modification I found on the site. 4. I re-fitted the safety lever pin and did the "bending" operation I also found here, that's acceptably tight now. 5. Discovered that the chromed "INTERARMS" mag that came with the pistol is actually a Mecgar. 6. I removed the hold-open pending receipt of the spring. 7. Tomorrow we're going to the range to try some WWB, Chinese 124gr., and some 1950s Canadian "CIA" mil-surp ammo. It's been a productive week. I hope some of the work paid off and I can report some success!