29/70 magazine feed problem. Help please.

pitsword · 12-03-2008, 04:14 PM

Hello Gerben and Sieger,
Thank you for the input. I do believe that it is a spring issue. The mag springs in the Mauser mags are substantially (a lot) stronger than the Mec-Gar springs. That's part of the reason that I cannot get the toggle to hold open after last round with the Mec-Gar mags.

The Mec-Gar mags seem to be a little looser in the mag well. Luckily my Mauser mags are ok. I will use them and get some wolff replacement springs. Do you know if the wolff springs will be stronger than the Mec-Gar?

Gerben, once again you are there with good advice. Thank you and Sieger thank you. This forum is the greatest. Best to all.
Pitsword

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-03-2008, 04:14 PM	#4
pitsword User Join Date: Jun 2008 Location: Southern Maine Posts: 459 Thanks: 3,964 Thanked 103 Times in 83 Posts	Hello Gerben and Sieger, Thank you for the input. I do believe that it is a spring issue. The mag springs in the Mauser mags are substantially (a lot) stronger than the Mec-Gar springs. That's part of the reason that I cannot get the toggle to hold open after last round with the Mec-Gar mags. The Mec-Gar mags seem to be a little looser in the mag well. Luckily my Mauser mags are ok. I will use them and get some wolff replacement springs. Do you know if the wolff springs will be stronger than the Mec-Gar? Gerben, once again you are there with good advice. Thank you and Sieger thank you. This forum is the greatest. Best to all. Pitsword