An air soft

Steinar · 12-03-2008, 12:29 PM

Wow.. that's one fantastic C96!
(Why is this tread called 'An air soft' instead of 'An incredible C96'?)

I notice there is VERY tight tolerances between the T-shaped notch on the floorplate and the cut for it on the frame. Perhaps this is the tight spot, and that your C96 actually came from the factory with this little 'fault'?

Just a thought.. but how about removing the magazine spring and push down latch, and slide the floorplate back and forward until it becomes more loose?

Btw. I have seen a manual removal of the floorplate was illustrated with a hand using the tip of a bullet for pushing it down.

12-03-2008, 12:29 PM	#8
Steinar User Join Date: May 2004 Posts: 1,538 Thanks: 18 Thanked 36 Times in 21 Posts	Wow.. that's one fantastic C96! (Why is this tread called 'An air soft' instead of 'An incredible C96'?) I notice there is VERY tight tolerances between the T-shaped notch on the floorplate and the cut for it on the frame. Perhaps this is the tight spot, and that your C96 actually came from the factory with this little 'fault'? Just a thought.. but how about removing the magazine spring and push down latch, and slide the floorplate back and forward until it becomes more loose? Btw. I have seen a manual removal of the floorplate was illustrated with a hand using the tip of a bullet for pushing it down. __________________ Previously known as Morgan Kane

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode