1917 DWM Luger with a bent frame

policeluger · 11-15-2008, 07:59 PM

I would try and un-couple the toggle link as the gun is now, a bit hard but not impossible. Chuck it up in a protected jaws of a heavy duty vice, down around the top of the grip panel area, with brass hammer and heavy brass stock pins, give it more of a try.....rubber mallet may to to soft, and you need more of a push.....slow and easy.....hope this is of some help

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-15-2008, 07:59 PM	#5
policeluger RIP Join Date: Jun 2002 Location: Ca. Posts: 2,141 Thanks: 8 Thanked 89 Times in 54 Posts	I would try and un-couple the toggle link as the gun is now, a bit hard but not impossible. Chuck it up in a protected jaws of a heavy duty vice, down around the top of the grip panel area, with brass hammer and heavy brass stock pins, give it more of a try.....rubber mallet may to to soft, and you need more of a push.....slow and easy.....hope this is of some help