Sticking Extractor

jrx15759 · 07-29-2008, 05:29 PM

I field stripped the bolt & toggle assembly from the gun and pulled the front of the extractor up but it doesn't go back down by itself. You have to push it down. The gun is a Mitchell luger made in 1991 with very little if any use. I bought a repro extractor from Numrich gun parts but it does the same thing as the stock extractor. The extractor cut is clean as a whistle. I had to dremel the front of the repro extractor similar to the stock extractor so the bolt would close completely. Do you think I could polish the sides of the extractor with my dremel tool?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-29-2008, 05:29 PM	#4
jrx15759 User Join Date: Jul 2008 Posts: 6 Thanks: 0 Thanked 0 Times in 0 Posts	I field stripped the bolt & toggle assembly from the gun and pulled the front of the extractor up but it doesn't go back down by itself. You have to push it down. The gun is a Mitchell luger made in 1991 with very little if any use. I bought a repro extractor from Numrich gun parts but it does the same thing as the stock extractor. The extractor cut is clean as a whistle. I had to dremel the front of the repro extractor similar to the stock extractor so the bolt would close completely. Do you think I could polish the sides of the extractor with my dremel tool?