P08 Malfunction...

lugerholsterrepair · 07-01-2008, 04:18 PM

Marlan, You can pop this part out relatively easily. At the back of the pistol where the spring ends in a square, there is a tiney well under this end carefully slip a tiney flat head screwdriver under this end and gently pry upwards. A short round holding pin will pop out of it's socket. The spring then can be removed.

With the bolt out, like John says..you can see if the tip is missing. It will stick right into the chamber area if it is intact. You can see it easily.

Jerry Burney

07-01-2008, 04:18 PM	#5
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Marlan, You can pop this part out relatively easily. At the back of the pistol where the spring ends in a square, there is a tiney well under this end carefully slip a tiney flat head screwdriver under this end and gently pry upwards. A short round holding pin will pop out of it's socket. The spring then can be removed. With the bolt out, like John says..you can see if the tip is missing. It will stick right into the chamber area if it is intact. You can see it easily. Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode