Luger locking bolt spring

Lugerdoc · 07-01-2008, 10:17 AM

I have both locking bolt & HO springs made in Germany. Usually after installing a new LB spring (make sure that it is pressed all the way into the frame so that it is flush at the bottom) it will be difficult to reinstall the TD lever. I usually push lever from the left side and tap down on it inside the frame, until it is low enough to go thru the hole on the right side. This can be a bit tricky the first time you try it. Lugerdoc

07-01-2008, 10:17 AM	#5
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	I have both locking bolt & HO springs made in Germany. Usually after installing a new LB spring (make sure that it is pressed all the way into the frame so that it is flush at the bottom) it will be difficult to reinstall the TD lever. I usually push lever from the left side and tap down on it inside the frame, until it is low enough to go thru the hole on the right side. This can be a bit tricky the first time you try it. Lugerdoc __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode