Luger locking bolt spring

lugerholsterrepair · 06-30-2008, 05:25 PM

Skorper,Take the top cannon off the pistol.. Place the pin untill it lined up with the hole as best it can. With the cannon off you can look directly into the well and be on top of the pin. Take a wood stick, preferably your Wife's cuticle stick and from the top push the pin down untill it lines up . It has a slight curvature. When it is pushed into the hole it will form an arc to keep the locking bolt in place. The short end of the pin should be nicely rounded. This will help guide it into the hole.
If you have bought a repro you are screwed. Throw it away and see if Tom Heller has an original.
Good Luck!
Jerry Burney

06-30-2008, 05:25 PM	#2
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Skorper,Take the top cannon off the pistol.. Place the pin untill it lined up with the hole as best it can. With the cannon off you can look directly into the well and be on top of the pin. Take a wood stick, preferably your Wife's cuticle stick and from the top push the pin down untill it lines up . It has a slight curvature. When it is pushed into the hole it will form an arc to keep the locking bolt in place. The short end of the pin should be nicely rounded. This will help guide it into the hole. If you have bought a repro you are screwed. Throw it away and see if Tom Heller has an original. Good Luck! Jerry Burney __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode