Cocking or not firing problem?

Kyrie · 11-05-2001, 08:16 PM

Hi Steve,

Assuming the piece is all original (i.e. matching), in my experience the most common cause of the problem you are experiencing is a worn sear bar plunger. Inspect this part carefully, looking to see if the surface of the sear bar plunger against which the trigger lever bears is worn. If it is, the cure is a replacement sear bar plunger.

Hope this helps!

Best regards,

Kyrie

11-05-2001, 08:16 PM	#7
Kyrie User Join Date: Jun 2002 Posts: 757 Thanks: 0 Thanked 212 Times in 101 Posts	Re: Cocking or not firing problem? Hi Steve, Assuming the piece is all original (i.e. matching), in my experience the most common cause of the problem you are experiencing is a worn sear bar plunger. Inspect this part carefully, looking to see if the surface of the sear bar plunger against which the trigger lever bears is worn. If it is, the cure is a replacement sear bar plunger. Hope this helps! Best regards, Kyrie

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode