Brass drift punch?

Ray K · 01-25-2008, 11:52 PM

What's the diameter of the brass drift punch required to remove the extractor in a P08? And, where are they available if I decide not to make one myself? Thanks. I've seen some advertised for $30+ but would rather just buy a cheap one that does the job.

j.rom · 01-26-2008, 03:59 AM

I am using a wooden toothpick for this job. Put your thumb on top of the breach block, push extractor a little bit down and then push the pin with a toothpick. It always works for me. Be careful not to loose the small spring under the extractor.

Regards,
Jan.

01-25-2008, 11:52 PM	#1
Ray K User Join Date: Nov 2007 Posts: 23 Thanks: 0 Thanked 0 Times in 0 Posts	Brass drift punch? What's the diameter of the brass drift punch required to remove the extractor in a P08? And, where are they available if I decide not to make one myself? Thanks. I've seen some advertised for $30+ but would rather just buy a cheap one that does the job. __________________ Ray Kammer Orlando, Florida

01-26-2008, 03:59 AM	#2
j.rom New User Join Date: Dec 2005 Location: Atlanta, GA Posts: 4 Thanks: 0 Thanked 0 Times in 0 Posts	Brass drift punch? I am using a wooden toothpick for this job. Put your thumb on top of the breach block, push extractor a little bit down and then push the pin with a toothpick. It always works for me. Be careful not to loose the small spring under the extractor. Regards, Jan.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode