The little "Prototype" that wasn't

Ron Wood · 01-10-2008, 12:31 PM

I suspect that in the photo the fact that the rear toggle link is not flush with the receiver rails is due to the toggle train not being fully into battery. You can see that the toggle is still buckled at the joint. Perhaps the action was eased down and the toggle latch was not fully engaged and was holding the action open a wee bit. Try closing the action vigorously or push down on the toggle joint and see if it flattens out.

01-10-2008, 12:31 PM	#1
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,051 Thanks: 1,121 Thanked 5,287 Times in 1,728 Posts	I suspect that in the photo the fact that the rear toggle link is not flush with the receiver rails is due to the toggle train not being fully into battery. You can see that the toggle is still buckled at the joint. Perhaps the action was eased down and the toggle latch was not fully engaged and was holding the action open a wee bit. Try closing the action vigorously or push down on the toggle joint and see if it flattens out. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode