Shoulder Stock Law ???

John D. · 10-22-2001, 09:29 AM

I made reference to the Stock Lug being used as part of the manufacturing process (to hold the frame during manufacturing) on the old Board when this thread arose.

My comment was specific to Krieg production. The source was Gibson (of course!:-) in the first or second Chapter, specifically where there are references to some of the differences between the stock lugs on Krieghoff, Mauser, Simson, etc.. I'll try to find a page reference later today..!!!

10-22-2001, 09:29 AM	#12
John D. Administrator & Site Owner LugerForum Patron Join Date: Jun 2002 Location: A Little NE of Somewhere... Posts: 2,651 Thanks: 478 Thanked 517 Times in 129 Posts	Re: Question on the amount of stock use I made reference to the Stock Lug being used as part of the manufacturing process (to hold the frame during manufacturing) on the old Board when this thread arose. My comment was specific to Krieg production. The source was Gibson (of course!:-) in the first or second Chapter, specifically where there are references to some of the differences between the stock lugs on Krieghoff, Mauser, Simson, etc.. I'll try to find a page reference later today..!!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode