LP08 Sight Adjustment Tool

Big Norm · 09-30-2007, 10:24 PM

Ron, I doubt seriously that the loading tool pocket or the cleaning rod would have the room to also squeeze a sight adjusting tool. Both those pockets are pretty snug fits. The best bet is that it was done at the factory. If the sight was still off badly then probably the armorer would adjust the sight. If that didn't work then the soldier was probably dead and the pistol became a war trophy for one of the allies soldiers. In war, close only counts in horse shoes and hand grenades... not in pistols.
Big Norm

If you want to make God laugh...tell Him your plans.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-30-2007, 10:24 PM	#2
Big Norm RIP Join Date: Jun 2002 Location: SE Michigan Posts: 1,864 Thanks: 1 Thanked 6 Times in 5 Posts	Ron, I doubt seriously that the loading tool pocket or the cleaning rod would have the room to also squeeze a sight adjusting tool. Both those pockets are pretty snug fits. The best bet is that it was done at the factory. If the sight was still off badly then probably the armorer would adjust the sight. If that didn't work then the soldier was probably dead and the pistol became a war trophy for one of the allies soldiers. In war, close only counts in horse shoes and hand grenades... not in pistols. Big Norm If you want to make God laugh...tell Him your plans.