Is there a subtle difference in DWM & Mauser Grip Screws?

Luke · 10-03-2001, 04:04 PM

on 7/13/01 Hugh Clark posted the following:

****The grip screws were apparently made in two sizes, I don't know when, where, how or who. They were made in 3/16"x32tpi, and in 4.5mmx.8 thread pitch. I just bought the set of Luger dies and taps that Sam Buscemi had for sale. According to him the 4.5x.8 mm is a rare configuration.****

My guess is that the early DWM had one type and the Mauser had the other.

Luke

10-03-2001, 04:04 PM	#9
Luke User Join Date: Jun 2002 Location: NC - USA Posts: 1,239 Thanks: 0 Thanked 19 Times in 7 Posts	Think I found the ANSWER on 7/13/01 Hugh Clark posted the following: **The grip screws were apparently made in two sizes, I don't know when, where, how or who. They were made in 3/16"x32tpi, and in 4.5mmx.8 thread pitch. I just bought the set of Luger dies and taps that Sam Buscemi had for sale. According to him the 4.5x.8 mm is a rare configuration.** My guess is that the early DWM had one type and the Mauser had the other. Luke

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode