Help--Receiver rail is warped!!

Pete Ebbink · 06-26-2007, 09:27 PM

Hi Brien,

The 1st. photo you posted appears to show a deep dent/pinch/crimp along the left side of the barrel as well...near the barrel shoulder (i.e. about 1 inch away...) where it screws into the receiver.

The "roundness" of your barrel and its ability to SAFELY allow a bullet to travel its length would be a big doubt and concern if this one were mine.

If you have a chance to return and get a refund, you would probably be better off...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-26-2007, 09:27 PM	#5
Pete Ebbink User Join Date: Jun 2002 Location: The USA Posts: 5,919 Thanks: 0 Thanked 7 Times in 5 Posts	Hi Brien, The 1st. photo you posted appears to show a deep dent/pinch/crimp along the left side of the barrel as well...near the barrel shoulder (i.e. about 1 inch away...) where it screws into the receiver. The "roundness" of your barrel and its ability to SAFELY allow a bullet to travel its length would be a big doubt and concern if this one were mine. If you have a chance to return and get a refund, you would probably be better off...