John Martz Luger Carbine

09-04-2006, 06:20 PM

Does anyone have an early John Martz Carbine. He said on early ones he made a fork at the rear of the support for the fore stock so as not to destroy the original serial number. I would appreciate seeing a picture of how it was made and attached.

Lugerdoc · 09-05-2006, 10:51 AM

RG, Sorry I don't have one or a photo, but as I recall, the only difference was that he cut out a section of the forearm support, where it would normally be silver soldered to the front of the frame, covering the serial #. TH

09-05-2006, 09:16 PM

Thanks, I appreciate your answer.

09-04-2006, 06:20 PM	#1
RGARRETT Guest Posts: n/a	John Martz Luger Carbine Does anyone have an early John Martz Carbine. He said on early ones he made a fork at the rear of the support for the fore stock so as not to destroy the original serial number. I would appreciate seeing a picture of how it was made and attached.

09-05-2006, 10:51 AM	#2
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	RG, Sorry I don't have one or a photo, but as I recall, the only difference was that he cut out a section of the forearm support, where it would normally be silver soldered to the front of the frame, covering the serial #. TH __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-05-2006, 09:16 PM	#3
RGARRETT Guest Posts: n/a	Thanks, I appreciate your answer.