Making a .357 Sig Luger Carbine

John Sabato · 04-29-2006, 02:04 AM

I don't believe the magazine or magazine well would be naturally wide enough to support the size of the case behind the shoulder for the .357

The breechblock face would definitely have to be enlarged... and the extractor modified to accept the new case head. Since the original design would be changed and the metal that would normally contain the 9mm round would be reduced, I don't think I would ever try using any hot loads..

All that said, a properly equipped pistol smith with access to machine tools should be able to make this modification. The mag well would have to be widened to accept what ever magazine would have to be created to accept the new cartridge...

Not an impossible task, but not a project for an amateur that doesn't have a gunsmith/master-machinest as a best friend and mentor.

Just my $0.02

04-29-2006, 02:04 AM	#2
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,309 Times in 1,098 Posts	I don't believe the magazine or magazine well would be naturally wide enough to support the size of the case behind the shoulder for the .357 The breechblock face would definitely have to be enlarged... and the extractor modified to accept the new case head. Since the original design would be changed and the metal that would normally contain the 9mm round would be reduced, I don't think I would ever try using any hot loads.. All that said, a properly equipped pistol smith with access to machine tools should be able to make this modification. The mag well would have to be widened to accept what ever magazine would have to be created to accept the new cartridge... Not an impossible task, but not a project for an amateur that doesn't have a gunsmith/master-machinest as a best friend and mentor. Just my $0.02 __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode