Luger Feeding Issues?

Vboy · 04-07-2006, 07:21 PM

If the top round in the mag is being stripped but isn't going all the way into the chamber, the problem might be a weak recoil spring. If the toggle isn't going back far enough to strip the round and put it into the chamber, the problem might be weak mag springs and/or a recoil spring that is a bit too strong. I would do some polishing of the feed ramp and rails, some cleaning and lubricating, and perhaps get stronger mag springs from Wolff. Of course, feeding problems can be caused by many factors and can be hard to solve. Good luck.

Vboy

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

04-07-2006, 07:21 PM	#1
Vboy User Join Date: Jun 2004 Location: Tennessee Posts: 35 Thanks: 0 Thanked 0 Times in 0 Posts	If the top round in the mag is being stripped but isn't going all the way into the chamber, the problem might be a weak recoil spring. If the toggle isn't going back far enough to strip the round and put it into the chamber, the problem might be weak mag springs and/or a recoil spring that is a bit too strong. I would do some polishing of the feed ramp and rails, some cleaning and lubricating, and perhaps get stronger mag springs from Wolff. Of course, feeding problems can be caused by many factors and can be hard to solve. Good luck. Vboy