wood bottom mag. question

G.T. · 09-25-2004, 12:02 AM

Hi Ed! after you press the new button into the follower, you have to set the checkerd face of the button on a piece of aluminum, and re-rivet the pin end using a small, (I believe #2) Stanley nail set... it is accessed thru the small hole on the off slot side! don't get to agressive, or you'll bend the follower button, but one smart rap should do the trick! Good luck! til...lat'r...GT

09-25-2004, 12:02 AM	#10
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	Hi Ed! after you press the new button into the follower, you have to set the checkerd face of the button on a piece of aluminum, and re-rivet the pin end using a small, (I believe #2) Stanley nail set... it is accessed thru the small hole on the off slot side! don't get to agressive, or you'll bend the follower button, but one smart rap should do the trick! Good luck! til...lat'r...GT