LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Repairs, Restoration & Refinishing

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Unread 12-27-2016, 10:32 AM   #8
mrerick
Super Moderator - Patron
LugerForum
Life Patron
 
mrerick's Avatar
 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,920
Thanks: 1,377
Thanked 3,135 Times in 1,518 Posts
Default

If the striker is not stuck with the pin exposed in the breech, it's slipping off the sear bar.

This area is complex and hand fit.

Start by checking to see if the little plunger and it's spring at the front of the sear bar is functioning properly. No resistance to being pushed in and springing back out. This is the disconnector. If it's not pushing in properly it could be tripping the sear.

Check ot make sure that the trigger plate is being held flat and solidly against the side of the receiver and frame.

Make sure that the sear is properly seated.

Verify that the sear and the mating surface on the firing pin are sharp and true. Wear or an improper angle or someone's attempt at "improving" the trigger might have made it unsafe.

This work is an area for an experienced Luger gunsmith. Very few regular gunsmiths have ever dealt with the complexity of this trigger system.
__________________
Igitur si vis pacem, para bellum -
- Therefore if you want peace, prepare for war.
mrerick is offline   Reply With Quote
The following member says Thank You to mrerick for your post:
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 08:59 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Lugerforum.com